ENGINE ELECTRONIC CONTROLS 14.1 ENGINE ELECTRONIC CONTROLS DESCRIPTION The Detroit Diesel Electronic Control System (DDEC) is an electronic fuel injection and control system. The system optimizes control of critical engine functions which affect fuel economy, performance, and emissions. The DDEC system provides the capability to protect the engine from serious damage resulting from conditions such as high engine temperatures or low oil pressure. The major subsystems of DDEC include:
Motor Control Module (MCM) Common Powertrain Controller (CPC) Electronic Injectors System Sensors The MCM receives electronic inputs from sensors on the engine and vehicle and uses the information to control engine operation. The MCM computes fuel timing and fuel quantity based upon predetermined calibration tables in its memory. The MCM precisely times and meters fuel to each injector. Detroit Diesel Diagnostic Link® (DDDL), a sophisticated software package supporting the set up, maintenance and repair of engines using DDEC, facilitates access to DDEC's diagnostic capabilities.
Used as a diagnostic tool DDDL can be used to change the engine rating, view an audit trail of CPC changes, monitor fault codes as they occur, snapshot recording, set the MCM output functions to particular values to support troubleshooting, and configure and change CPC parameter values. DDEC VI provides one industry standard serial data link: SAE Standard J1939. SAE Standard J1939 provides control data to other vehicle systems such as transmissions and ABS control devices. High-speed CAN link is also used for transmittals between the CPC and MCM modules.
14.2 ORIGINAL EQUIPMENT MANUFACTURER INSTALLATION REQUIREMENTS Original Equipment Manufacturer (OEM) supplied hardware is required to install DDEC VI. The following is the minimum hardware required: 31–pin Vehicle Interface Harness assembly (VIH) — This harness connects the vehicle functions and DPF harness to the MCM 21–pin Vehicle Interface Harness (VIH) assembly — This harness connects battery power (12 volts) and ground to the MCM and CPC, includes fuse(s) or circuit breaker(s), and CAN lines for communication between MCM and CPC.
Ignition switch — Switched 12 volt ignition Amber Warning Lamp (AWL) — A panel mounted amber indicator light Red Stop Lamp (RSL) — A panel mounted red indicator light Throttle input device — An electronic foot pedal assembly (EFPA), hand throttle, or alternative throttle device 14-2 All information subject to change without notice. DDC-SVC-MAN-0073 Copyright © 2009 DETROIT DIESEL CORPORATION