MAN — MAN DD13 DD15 Engine Application Installation Manual

DD PLATFORM APPLICATION AND INSTALLATION MANUAL 16.2 PREPARATION The engine must be properly maintained and in optimum operating condition, to assure acceptable cold weather starting and satisfactory operation, the following areas must be addressed. Lubricating Oil Diesel Fuel Coolant Battery Starter Motor 16.2.1 LUBRICATING OIL Detroit Diesel engines will deliver optimum year round performance and long service life with the recommended lubricating oil. To keep current with the acceptable oils, refer to DDC publication Lubricating Oil, Fuel and Filter Recommendations (DDC-SVC-BRO–0001) available at detroitdiesel.com.

Starting and operation of the engine at cold temperatures may require additional considerations in the selection of the lubricant. As ambient temperatures decrease, the oil viscosity increases or thickens. If the temperature is low enough, it will turn solid. Attempting to start an engine with very thick oil places excessive stress on the engine and starter components; starting the engine with oil too thick to pump and circulate through out the engine may cause engine failure or failure to start. Generally, lower viscosity grade oils should be used at lower temperatures.

To counteract this effect, either auxiliary heat must be introduced to maintain proper oil viscosity, or the lubricating oil grade may be changed to lower viscosity for ease of engine starting. Lube oil heaters for raising oil temperature at cold ambient temperatures are discussed later on in this chapter. Unfortunately, low viscosity oils do not provide adequate wear protection at higher engine temperatures. The use of multigrade oil can provide benefits at low starting temperatures and at higher operating temperatures. These oils are generally identified using both a low and high temperature designation with a "W" between.

For example 15W40 indicates the meets the low temperature requirements of a 15 grade oil and the high temperature requirements of a 40 grade oil. At low ambient temperatures, below -0°C (14°F), SAE 5W-30, 10W-30, 5W-40 or 10W-40 oils may be used, provided they are API CJ-4 (low ash) oils. Please refer to DDC publication (DDC-SVC-BRO–0001) for more information. All information subject to change without notice. 16-3 DDC-SVC-MAN-0073 Copyright © 2009 DETROIT DIESEL CORPORATION