Maintenance—Every 1000 Hours Drain and Refill Winch Oil and Replace Filter—If Equipped T118733B —UN—03DEC98 T118732D —UN—27APR99 Winch Shown Removed for Clarity of Photo Winch oil filter (A) is located on right side between winch and crawler . Winch Oil Filter 1. Remove three cap screws from oil filter access cover. 2. Remove oil filter access cover. 3. Remove filter (C) by turning counterclockwise. T119546B —UN—14JAN99 4. Remove drain plug (B). Allow oil to drain into container. Dispose of waste properly. 5. Install drain plug. 6. Apply a thin film of oil to gasket of new filter. 7. Install new filter. Winch Fill Port 8.
Fill winch oil reservoir through fill port located at top of winch (E) with 34 L (9 gal) of oil. See Final Drive and Winch Oil. (Section 3-1.) 9. Add remaining 4 L (1 gal) of oil through dipstick fill port (D). T133718D —UN—29AUG02 10. Check winch oil. See Check Winch Oil—If Equipped. (Section 3-4.) 11. Install oil filter access cover with three cap screws. A—Oil Filter B—Drain Plug C—Filter D—Dipstick Fill Port E—Fill Port Dipstick Fill Port CED,OUO1032,1179 -19-05FEB13-1/1 3-8-4 070813 PN=112