John Deere 450H, 550H, 650H — Hydraulic System Checks

Miscellaneous—Operational Checkout Visual Check Park machine on level surface. Lower all equipment to ground. LOOK: Hydraulic oil must be visible in sight glass located inside right rear access door. OK: Go to next check. LOOK: Hydraulic lines and fitting must not seep or leak oil. NOT OK: Add oil. See Change Hydraulic Oil and Filter. (Section 3-9.) LOOK: Cylinder seals must not seep or leak oil. NOT OK: Repair leaks. See your authorized dealer. HG31779,00000D1 -19-03SEP02-40/57 Drift Check Operate engine at slow idle. Place dozer blade 50 mm (2 in.) from ground. OK: Go to next check. LOOK: Blade must NOT touch ground within two minutes. NOT OK:

Determine if drift is excessive for your operation, see your authorized dealer. HG31779,00000D1 -19-03SEP02-41/57 Control Valve Lift Check Test T6583AE —UN—23AUG93 Raise dozer approximately 305 mm (1.0 ft) above ground. Stop engine. Pull blade lever control lever. LOOK: Blade must not lower. Start engine and raise front of machine, tilt full right. Stop engine. Push blade level control lever to power down position and tilt right. LOOK: Machine must not lower. Start engine and tilt blade full left. Stop engine. Push blade level control lever to tilt left. OK: Go to next check. LOOK: Machine must not lower. NOT OK: Inspect lift check in valve. See your authorized dealer.

HG31779,00000D1 -19-03SEP02-42/57 Blade Float Check Raise front of crawler off of ground with blade. Push blade level control lever into float detent. LOOK: Front of crawler must lower to ground. OK: Go to next check. FEEL: Blade level control lever must stay in float detent position. NOT OK: Inspect and repair valve detents. See your authorized dealer. Continued on next page HG31779,00000D1 -19-03SEP02-43/57 4-2-13 070813 PN=152