John Deere 450H, 550H, 650H — Undercarriage Checks

Miscellaneous—Operational Checkout Hydraulic Pump Performance Check T6583AE —UN—23AUG93 Hydraulic oil must be at operating temperature 66°C (150°F). Operate engine at slow idle. Place blade on ground. OK: Go to next check. Record time required to raise blade. NOT OK: Check oil level and condition. See Check Hydraulic Oil Level. (Section 3-4.) LOOK: Maximum cycle time 7.5 seconds. NOT OK: See your authorized dealer. HG31779,00000D1 -19-03SEP02-44/57 Undercarriage Checks HG31779,00000D1 -19-03SEP02-45/57 Track Sag Roller and Idler Leakage Checks T119010 —UN—14DEC98 Measure track sag at longest span of unsupported track. LOOK: Track sag must be 51 ± 6 mm (2 ± 1/4 in.). OK: Go to next check.

Inspect rollers and front idler. NOT OK: Adjust track sag. See Adjust Track Sag. (Section 3-3.) LOOK: No oil seepage must be noted from roller or idlers. NOT OK: Repair or replace roller or idler. See your authorized dealer. HG31779,00000D1 -19-03SEP02-46/57 Grouser Wear, Bent Track Shoe, and Loose Hardware Checks Inspect for worn grousers, bent track shoes and loose shoe hardware. LOOK: Grouser bars must NOT be worn excessively and track shoes must NOT be bent and hardware must be tight. OK: Go to next check. NOTE: Excessive grouser wear weakens track shoes and may re- sult in track shoes bending. NOT OK: If shoe hardware is loose, remove shoe and clean joint before tightening.

See Checking Track Shoe Cap Screw Torque. (Section 4-1.) Continued on next page HG31779,00000D1 -19-03SEP02-47/57 4-2-14 070813 PN=153