Operation—Operator's Station Q—Hour Meter: Use to determine when your machine needs periodic maintenance. displayed in the gauge window (1). The speed range is displayed as a two digit value. The values can range from SP1.0 to SP3.0. When the transmission speed control button (located on FNR lever) is pressed and held in the “Up” position, the range SP value can reach a maximum value of SP3.0. When the speed control button is held in the “Down” position, the value will decrease to a minimum of SP1.0. R—Under-Seat Heater ON/OFF Switch: Push upper half of switch to turn heater on. Push lower half to turn heater off. S—Transmission Speed Setting Gauge Display—If Equipped:
When the machine is started, the transmission gauge speed setting default range of SP1.6 will be HG31779,00000AB -19-11JUL02-2/2 Instrument Panel (Later Machines) T157845B —UN—22JUL02 1— Select Button 2— Display Window 3— Engine Coolant Temperature Gauge 4— Engine Oil Pressure Gauge 5— Fuel Level Gauge 6— Seat Belt/Park Brake Indicator (Red) 7— Engine Alternator Voltage Indicator (Yellow) 8— Engine Air Filter Restriction Indicator (Yellow) 9— Hydraulic Oil Filter Indicator (Yellow) 10— Hydraulic Oil Temperature (Yellow) Transmission Oil Filter Indicator (Yellow) 12— Transmission Oil Temperature Indicator (Yellow) 13— Check Service Code Indicator (Yellow) 14— Stop Indicator (Red) 15— Start Aid Button 16— Front and Rear Work Lights Switch 17— Transmission Oil Pressure Gauge 18— Under-Seat Heater ON/OFF Switch 19— Key Switch IMPORTANT:
When the STOP-engine indicator is activated, stop engine immediately and investigate cause of problem. DO NOT start engine until problem has been corrected. Each display indicator light is color-coded to indicate the severity of the situation. Red is a high-level warning, yellow is a low-level warning and clear indicates a condition. When a red indicator lights, an audible alarm will sound. Stop the engine immediately and investigate the cause of the problem. HG31779,0000091 -19-04JUN02-1/1 2-1-3 070813 PN=29