John Deere 450H, 550H, 650H — Loading Machine on a Trailer

Operation—Operating The Machine Loading Machine on a Trailer 1. Keep the trailer bed clean. 2. Put chock blocks (A) against truck wheels. 3. Use a ramp or loading dock. Ramps must be strong enough, have a low angle, and be of correct height. 4. Fasten seat belt before starting engine. T87155 —UN—09NOV88 5. Load and unload the machine on a level surface. CAUTION: Prevent possible injury from unexpected machine movement. Whenever possible, back the machine onto the trailer to prevent possible tipping. 6. Drive the machine onto the ramps squarely. A—Chock Blocks 7. The centerline of the machine should be over the centerline of the trailer. 16. Turn battery disconnect switch off. 8.

Lower all equipment onto blocks. 17. Cover exhaust opening to prevent entry of wind and water. 9. Move FNR lever to N. IMPORTANT: Fasten chains or cables to machine frame or track chain links. Do not place chains or cables over or against hydraulic lines or hoses. 10. Move park lock lever to lock position. IMPORTANT: To avoid damage to turbocharger (if equipped), run engine at 1/2 speed no load for two minutes. 18. Fasten each corner of the machine to the trailer with a chain or cable. Front: Use towhook eye on bottom of the machine frame front end. Side: Use inside edge of track shoe. Rear: Use outer edge of track shoe or drawbar (if equipped). 11.

Run engine at 1/2 speed no load for 2 minutes. 12. Move engine speed control lever to slow idle position. 13. Turn key switch to “Off”. Stop engine. 14. Remove key from switch. 15. Release hydraulic pressure by moving control lever until equipment does not move. 02T,40,K36 -19-07JAN00-1/1 2-2-36 070813 PN=74