John Deere 450H, 550H, 650H — Adjust Track Sag

Maintenance—As Required Check Track Sag Maintaining the proper amount of track sag is the single most important adjustment the operator can make. Tight tracks can reduced the amount of wear life by more than 50% over tracks which are properly maintained at 51 mm (2 in.) of sag. Tight tracks increase the loading on the undercarriage components and accelerate the wear rate. Track sag should be adjusted as the soil conditions change. See Track Sag General Information. (Section 4-1.) 1. Position track so that a track pin is centered over the carrier roller. 2. Measure sag of track between carrier roller and front idler from the top of track grouser (A) to a straight edge (B).

If adjustment is needed, see Adjust Track Sag in this section. Specification Track Sag—Distance........................................ 51 ± 6 mm (2 ± 0.250 in.) A—Grouser B—Straight-Edge T7800AH —UN—31JUL92 Proper Track Sag T120959 —UN—20APR99 Measure Track Sag TX,55,RR2718 -19-23MAY12-1/1 3-3-2 070813 PN=91