Payload Meter III - Section 60 2/11 OM6012 Page 60-6 The inclinometer displays whole degrees of incline. Positive incline is truck nose up. The gauge will quickly display the type of information shown every 10 seconds. For example, if the left front pressure is being displayed, LF Pres: will flash on the display every minute. PAYLOAD OPERATION & CALCULATION Description of Haul Cycles The typical haul cycle can be broken down into eight distinct “stages” or “states”. Each state requires the payload meter to make different calculations and store different data.
Left Front Pressure - To display the pressure in the left front suspension, press and release the OK position of the operator switch until LF Pres: is displayed. 1. Tare Zone 2. Empty 3. Loading Right Front Pressure - To display the pressure in the right front suspension, press and release the OK position of the operator switch until RF Pres: is displayed. 4. Maneuvering 5. Final Zone 6. Hauling Left Rear Pressure - To display the pressure in the left rear suspension, press and release the OK position of the operator switch until LR Pres: is displayed. 7. Dumping 8.
After Dump Right Rear Pressure - To display the pressure in the right rear suspension, press and release the OK position of the operator switch until RR Pres: is displayed. A new haul cycle is started after the load has been dumped from the previous cycle. The payload meter will stay in the after dump state for 10 seconds to confirm that the load has actually been dumped. If the current payload is less than 20% of rated load, the payload meter will switch to the tare zone and begin calculating a new empty tare. If, after dumping, the payload has not dropped below 20% of rated load the meter will return to the maneuvering or hauling states.
In this case, the false_body_up flag will be recorded in the haul cycle record. Inclinometer - To display the truck incline, press and release the OK position of the operator switch until Incline: is displayed. Other Display Messages On startup of the payload meter system, the operator display will scroll the truck type that the PLMIII is configured for. For example, on a 960E, the display While in the tare zone state, and moving faster than 5 km/h (3 mph), the payload meter calculates the empty sprung weight of the truck. This tare value will be subtracted from the loaded sprung weight to calculate the final payload.
The payload meter will switch from the tare zone or empty to the loading state if swingloads are detected. By raising the dump body while in the empty state the payload meter can be manually switched back to the tare zone to calculate a new tare. will scroll --- 960E --- . If the PLMIII encounters memory problems, it will display ER88 , where 88 is the specific memory error. In this very rare circumstance, the system should be turned off for 30 seconds and restarted. From the empty state, the payload meter will switch to the loading state through one of two means. If the brake lock is applied, the payload meter will be analyzing the suspension pressures to detect a swingload.
If a swingload is detected, the meter will switch to the loading state. The minimum size for swingload detection is 10% of rated load. Swingload detection usually takes 4-6 seconds. The second method to switch from empty to loading is through continuous loading. This can happen if the brake lock is not used during loading. If the load increases above 50% of rated load for 10 seconds without the brake lock applied, the meter will switch to loading and record the continuous_loading flag in the haul cycle.