Service Manual for WD10 Diesel Engine (2) Charging system fault diagnosis and troubleshooting a) No charging 125 Fault 1: No charging Phenomenon Fault detection Troubleshooting (1) Turn on starting key, but charging indicator doesn’t light. a. Check charging indicator lamp. b. Check whether there is open circuit in exciting circuit. a. Check whether there is voltage between charging indicator and ground, if no voltage, replace the indicator lamp or check the circuit. b. If it is generator regulator failure or generator rotor failure, repair or replace the generator. (2) Charging indicator doesn’t go out when engine idling, it only goes out when engine is in high speed. a.
Rated power of indicator lamp is small or parallel exciting resistance gets loose. b. Too low idling speed. a. 2~6w lamp is recommended, or repair the circuit. b. Adjust engine idling speed. (3) Charging indicator doesn’t go out when engine is working. a. Check whether generator to ground voltage is within 1~3V; a. If voltage of generator indicator end is very small, then it means rated power of indicator lamp is small or there is fake connection in the circuit. Adjust indicator lamp power or check the circuit (connector and connecting point). b. If voltage of generator indicator end is zero, then it means there is short circuit in exciting circuit, check the circuit. c.
If voltage of generator indicator end is battery voltage, then it means there is fault in exciting circuit, and generator regulator and exciting tube may be damaged in the same time, please amend the exciting circuit and then repair the generator.