Service Manual for WD10 Diesel Engine 424 Disassembly, Inspection, Maintenance and Assembly of Oil-Gas Separator 4241 Exploded View of Oil-Gas Separator Front hanger plate Fixing bolt Oil-gas separator Oil-gas separator outlet pipe Flange and gasket Clamp Oil-gas separator oil return pipe Bolt Clamp and bolt Clamp Oil-gas separator intake pipe joint Connecting pipe Fig.
4-5 Exploded view of oil-gas separator 4242 Steps to Disassemble Oil-Gas Separator (1) Remove the two fixing bolts of oil-gas separator intake pipe joint on cylinder block; (2) Remove the bolt that used to fix oil-gas separator on front hanger plate; (3) Remove the outlet pipe clamp and oil return pipe clamp of oil-gas separator, remove the clamp of oil sump return pipe; (4) If the connecting pipe that connected to oil-gas separator oil return pipe end needs to be disassembled, loose the pipe sleeve first. For further disassembly, refer to Fig. 4-5.
4243 Inspection and Maintenance of Oil-Gas Separator (1) Check appearance of each part, check them for failure as damage, crack and rubber pipe hardening, and replace relevant parts. (2) Check whether oil-gas separator is unblocked by inflating the intake pipe, if the airflow is not smooth, blow away the impurities and oil dirt with compressed air. Replace the oil-gas separator if necessary. 41