www.changlin.com.cn 17 mm Engines rated at 2500 RPM and above require additional fuel line support. Install as illustrated. Torque Value: 24 N• m [18 ft-lb] Injectors‐Replacement Preparatory Steps: Thoroughly clean around the injectors. Disconnect the high pressure fuel lines. Disconnect the fuel drain manifold. 16 mm, 24 mm Box Wrench Caution: The injector must not rotate in the bore of the cylinder head. This will damage the cylinder head. Remove the injectors. Hold the injector body with the 16 mm wrench while you loosen the hold-down nut with a 24 mm box end wrench. Clean the injector nozzle bore using Service Tool No. 3822509. 104 / 167 pages