TIC LEXION 480-405 Standard machine functions Flow control valve With the function “front end attachment fast drop”, the restricted oil flows through the restrictor in the flow control valve (19), back to tank. The pressure of the returning oil presses against the spool of the flow control valve, which moves back against the spring pressure opening up the ring channel allowing the oil to flow back to tank. Should the pressure drop from the connection (A), then the flow control opens and allows more flow through the restrictor. The regulating function of the valve is dependent on the pressure from the connector (A) and the force of the spring within the valve.
The flow rate can be adjusted from outside, by use of a hand wheel. By releasing the tension on the spring, reduces the amount of pressure required to operate the valve and therefore reduces the amount of oil allowed to flow through. Note The difference with the main valve (spare part no. 631 581.0) can be seen here in the pilot block of the function "Front attachment lower". In this version (spare part no. 631 581.0) the valve (E) works independently from the load pressure of the front attachment. This is done for safety's sake on heavy front attachments or when only two rams are fitted. Depending on this version, a corresponding CAC module must be used. 03/2004 3-27