19-63 Electrical System Troubleshooting z Error code 18-3 (4Y engine:
Crank angle sensor abnormality) Related portion G27 G18 Probable cause c Crank angle sensor defect d Harness defect e Engine controller defect Error code 18-3 Connector contact defect Harness defect Crank angle sensor defect Normal (Entry of foreign matter etc.) Engine controller defect Section 19 Engine controller 11 (G2) 1 (G2) 22 (G-) 2 (G-) Crank angle sensor Disconnect the battery negative terminal (for more than 10 seconds), after inspecting and correcting disconnection and water entry of G18, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (start the engine) and check whether or not there is an error. No error Error Inspection 1:
Harness continuity and short circuit inspection OK Inspection 2: Crank angle sensor individual inspection OK Inspection 3: Crank angle sensor installation inspection Install the crank angle sensor, connect G27, G18 and battery negative terminal, start the engine. Check whether an error occurs. Error