AIR CONDITIONING 1B-25 Receiver / Drier (4HK1-TC Engine Model For Australia) 2 1 4 3 N1A0198E Legend 1. Refrigerant line 3. Receiver / drier 2. Pressure switch 4. Condenser assembly Removal 3. Receiver / Drier Preparation: Disconnect the battery ground cable. Discharge and recover refrigerant. 1. Pressure Switch Connector 2. Refrigerant line Loosen the fixing bolt and carefully pull out the re- ceiver/drier. Installation To install, follow the removal steps in the reverse order, noting the following points: 1. If installing a new receiver/drier, be sure to add 30 cc (0.8 Imp fl oz) of new specified compressor oil to a new one. 2.
Put the receiver/drier in the bracket, and connect with the refrigerant line. Check that no excessive force is imposed on the line. Fasten the fixing bolt to the receiver/drier. Use a back up wrench when disconnecting and re- connecting the refrigerant line. When removing the line connected part, the con- necting part should immediately be plugged or capped to prevent foreign matter from being mixed into the line.