Maintenance - Section 4 OM4035.1 01/04 Page 4-8 Lubrication and Service 250 HOUR LUBRICATION AND MAINTENANCE CHECKS Maintenance for every 10 & 50 hour Lubrication and Maintenance Checks should also be carried out at this time. Truck Serial Number __________________________ Site Unit Number _____________________________ Date: __________ Hour Meter __________________ Name of Service Person _______________________ NOTE: "Lube Key" references are to the Lubrica- tion Specification Chart. 1. ENGINE - Refer to the engine Operation & Mainte- nance manual for complete specifications regarding engine lube oil specifications. NOTE:
If engine is equipped with the CENTINEL oil system and/or the ELIMINATOR filter system, engine oil and filter change intervals are extended beyond 250 hours. Refer to the engine Operation & Maintenance manual for specific oil & filter change intervals. a. Change engine oil. Lube Key “A”. b. Replace lube oil filters. NOTE: When installing spin-on filter elements, follow the instructions as specified by the filter manufacturer. The tightening instructions are normally printed on the outside of the filter. Do not use a wrench or strap to tighten filter elements. c. If truck is equipped with a Reserve Engine Oil Tank, change the reserve tank oil filter. d.
Check the fan belt tension.Refer to the engine Oper- ation & Maintenance manual for specific fan belt adjustment instructions. 2. HYDRAULIC SYSTEM FILTERS - Change filter ele- ments after the initial 250 hours; then each 500 hours of operation thereafter. 3. FUEL FILTER AND STRAINER - Change filter and strainer element. 4. MOTORIZED WHEEL GEAR CASE - Refer to the G.E. planned maintenance manual and specific motor- ized wheel service manual. 5. STEERING LINKAGE - (If not equipped with auto- matic lube system) - Add one or two applications of grease to each grease fitting for pin and bearing. Check torque on steering pin nuts 343 ± 34 ft. lbs. (465 ± 46 N.m) torque. Use Lube Key "E".
The Centinel system is a duty-cycle-dependent lubrication management system whereby oil is blended with the fuel and burned and an extension of oil change intervals can occur. COMMENTS CHECKED INITIALS