OM4035.1 01/04 Maintenance - Section 4 Lubrication and Service Page 4-9 250 HOUR LUBRICATION AND MAINTENANCE CHECKS (continued) 6. COOLING SYSTEM DCA WATER FILTER - Change spin-off filter. Check cooling system for proper coolant mixuture. Add water mixture as required. 7. HYDRAULIC PUMP & U-JOINT - Add one or two applications of grease to each grease fitting on the cross and bearing assemblies and splines. Use Lube Key "D". 8. FRONT WHEEL BEARINGS - Check oil level. 9. FUEL TANK - Drain H2O and sediment. 10. AXLE BLOWER MOTOR (If equipped with trolley system) - Add only one application of grease to each ball bearing on the blower shaft. Use lube Key "D". 11.
GE PREFILTER BLOWER - Add one or two appli- cations of grease to the grease fitting. Use Lube Key "D". 12. CHASSIS LUBE LEVEL - Check the level of grease in the supply canister. Add more grease to ensure the supply will not run out before the next scheduled ser- vice. Use Lube Key "D". 13. BATTERIES (NOT SHOWN) - Check electrolyte level and add water if necessary. COMMENTS CHECKED INITIALS