OPERATION INCREASING OR REDUCING TRACK FRAME GAUGE Never use the machine for operations with the track frame retracted. Never operate the cylinders suddenly when extending or retracting the track frame gauge width. It is dangerous if they are operated suddenly. Stop the machine on firm level ground when extending or retracting the track frame gauge width. REDUCING TRACK GAUGE 1. Remove center frame mounting bolts (1) front and rear 9 each on one side. 2. Swing the upper structure to the side where the track frame gauge is to be reduced, set it at 90 o to the track frame (2), then use the work equipment to jack up the track frame. 3.
Set blocks (3) 20 to 30 cm (8 to 12 in) wooden blocks towards the outside of the track frame (2), then use the boom cylinder to lower the machine slowly. The track frame (2) will slide and stop when it contacts the stopper. 4. Lower the machine slowly to the ground, then install 8 of the removed mounting bolts (front and rear: 4 each) Tightening torque: 1520 to 1910 Nm (1121 to 1410 ft/lbs) 5. Follow the same procedure to retract the track frame on the other side. 2-132 PC400LC-7E0