Komatsu — CHECK PIVOT BEARING OIL LEVEL, ADD OIL

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE CHECK PIVOT BEARING OIL LEVEL, ADD OIL When removing plug (1), be careful not to let dirt or dust get it. (B): 25mm (1inch) 4 - 74 3. Remo ve dipstick (G) , then remove dra in plug ( P) and dr ain the oil. After d raining the oil ,tighten drain plug 4. Add oi l through the holder of dipstick (G). Afte r adding the oil, insert dipstick (G). 5. Remo ve any dirt or dust stuck to brea ther (5), then wa sh with clean diesel oil or flushing oil. If with a new part. leaned completely, replace 6. Install undercover (2 ), then close engi ne side cover (1) on the left sid e of the mach Remo When ve plug (1). removing plug 2.

Check that the oil is up to oil level (2) in the di If the o il level is low, add oil through th e hole f or plug (1