Kenworth — Kenworth T170 T270 T370 and Hybrid 2011 Body Builders Manual

Section 8 Electrical FIGURE 8-25. Adding a Third Battery WIRING FOR A LIFTGATE CAUTION: Consult the liftgate manufacturer’s installation instructions for details concerning wir- ing for their product and specific model. A liftgate will usually require current much greater than 10 amperes. Typically, 100 to 150 amperes is required and some models require more than 150 amperes. For a liftgate installation a third battery is required for adequate power. Note: A liftgate installation must have a dedicated circuit to distribute power to the liftgate. Liftgate Power Source Liftgate motors will typically use DC power. A convenient power source is the battery. Use Figure 8-27 as a guide.

Install the circuit breaker inside the battery box on the rear panel. WARNING! DO NOT use a circuit breaker of lower capacity than the liftgate amperage requirements. If you do, it could result in an electrical overload or fire. Follow the liftgate installation instructions and use a circuit breaker with capacity recommended by the liftgate manufacturer. 8-31 12/11