Komatsu — CHECKS UNDER THE HOOD

OPERATION CHECKS UNDER THE HOOD Oil Level A. Be sure the machine is siting on a level surface before checking any fluid levels. B. Open the hood side panels and check oil level. Remove dipstick (G) be sure oil level is within the specified range. C. If oil level is low, add oil through fill port (F) if it is over full drain some oil out through the drain cock (P). Water Separator D. Check the water separator for any signs of water in the fuel, if traces of water are found in the separator, loosen drain plug (3) and drain the excess water from the separator until the float (1) falls to the bottom of the unit. Never allow the water level to go above the marking (2).

Remark When draining oil from the engine or water from the water separator always trap and recover these fluids for recycling purposes, never drain them onto the ground. Failure to recover these fluids is in violation of EPA laws. 2-52 WA320PT-5L