Komatsu — CUTTING OR DIGGING

OPTIONAL ATTACHMENTS CUTTING OR DIGGING When digging or cutting a grade on level ground, set the bucket edge facing down slightly. Always be careful not to load the bucket on one side and cause an unbalanced load situation. This operation should be carried out in 1st gear. Do not angle the bucket facing down more than 20 degrees. 1. Angle the edge of the bucket facing slightly down. 2. Using the left brake pedal and accelerator pedal drive the machine forward and operate the work equipment control lever to cut a thin layer of the surface each time when excavating the soil. 3. Move the work equipment up and down slightly as needed to reduce the resistance when driving the machine forward. 4.

When cutting a grade avoid racking the bucket to one side. Damage to the machine may result. 5-6 WA320PT-5L