SECTION 4 OPERATING Page 22 4.8. DRIVING THE MACHINE Fig. 4.19. Engine Speed and Shut Down Control Lever 1. Place the engine speed and shut down control lever in the high idle position. 2. Depress the decelerator pedal to decrease engine speed. 3. Move forward the neutral lock lever (3) from ON to OFF position. 4. Place the transmission shift lever in the desired range. Refer to SHIFTING THE TRANSMISSION 5. Gradually release the brake and decelerator pedal. 4.9. SHIFTING THE TRANSMISSION The transmission has three speeds in both the forward and reverse ranges. The ranges and speeds are controlled by the transmission shift lever. 4.10.
CONVERTER OVERHEATING If the pointer of the torque converter oil temperature gauge moves out of the RUN area of the dial during operation, the transmission may be in a gear range which is too high for the load. Shift down into the next lower gear range. The temperature should reduce; if not, downshift again. If the dial pointer remain out of the RUN range in first gear, stop the machine, shift into neutral and run the engine at 1000 RPM until the gauge pointer moves into the RUN area. Stop the engine, check transmission oil level, clean radiator and clean suction filter.
If the converter still remains overheated, stop the engine and consult Authorized Distributor of Construction Equipment before operating the machine. TD-20H DRESSTA