OPERATING SECTION 4 Page 23 4.11. STEERING THE MACHINE A – High Range B – Low Range C – Pivot Fig. 4.20. Steering Levers Steering is accomplished with the two steering levers. Each of the two levers function in three positions as shown in Fig. 4.20. – in forward position A transmits power to the track in high range – in middle position B transmits the power to the track in low range – in rearward position C disconnects the power and applies the brake To turn to the right or left pull back the steering lever on the side toward which the turn is to be made. Pull lever back just enough to make the desired turn. To make a pivot turn pull the lever all the way back.
To make a gradual left turn proceed as follows: With steering lever in high range move LH steering in low range. When both steering levers are in low range, move RH steering lever in high range. To make a gradual right turn proceed in similar manner. 4.12. LOCKING BOTH TRACKS When both steering levers are pulled simultaneously all the way back, the braking action stops both tracks. WARNING! Never pull both steering levers all the way back to stop the machine unless the machine is moving very slowly. Use the foot brake to slow down or stop the machine. DRESSTA TD-20H