OPERATING SECTION 4 Page 35 4.18. OPERATING TECHNIQUES Always cut the shelf wide enough to provide solid support for equipment using it later. If possible, move the material downhill to gain the advantage of gravity, reduced effort and increased tractor stability. Soft soil or shallow slopes may allow the side hill cut to be made as shown in Fig. 4.37. Increased stability is realized by running the uphill track inside the ridge left by the first cut. Cuts 3, 4 and 5 illustrate the completion of the shelf. Fig. 4.37. Shallow Slope Side Hill Cut Once again, pushing the loosened material to the lower side of the slope Fig. 4.38 will normally reduce time and cost.
Do not push material beyond the point required to retain firm track support. Fig. 4.38. Slope Edge Operation Fig. 4.39. Operating a Tandem Arrangement When backing up, do not raise the blade as this puts extra weight on the front idlers causing greater track penetration. Let the blade float as you back away from the edge of soft fills. Initial work on steep hillsides can be safer by either securing the tractor with a winch to a suitable uphill anchor point or by operating a tandem arrangement as shown in Fig. 4.39. When clearing trees, raise the blade high to gain leverage and make contact gently to reduce possible harm to the operator and machine (Fig. 4.40).
Heavy roots of large trees may require pushing and digging or cutting from several sides of the tree. Use a cable to topple and remove trees from soft ground (Fig. 4.41). DRESSTA TD-20H