SECTION 4 OPERATING Page 36 4.18. OPERATING TECHNIQUES Fig. 4.40. Machine Equipped with Sweeps Fig. 4.41. Using Cable to Remove Trees WARNING! Falling trees and dead limbs can cause injuries. When clearing trees, operator protection must be used. When clearing a rocky area, remove the small and loose rocks first, large and solid rocks can then be loosened and moved with less difficulty. When loosening large or solid rocks, greater force and penetration can be obtained by tilting the blade and prying under the rock with the lower edge of the blade (Fig. 4.42). Lifting the rock with the blade while pushing will increase traction and reduce track spinning. Fig. 4.42.
Loosening Rocks with Lower Edge of the Blade Penetration on hard, frozen or rocky ground can be made easier by tilting the blade. This will add weight and power to the lower cutting edge. When the ground is frozen and the area must be ripped before it can be worked, rip a relatively small section and work it to grade before enlarging the cut. This will require ripping each section only once, not every morning after the ground has refrozen. Snow can act as an insulating blanket and reduce or eliminate the need for a ripper. Therefore, remove snow only from the area to be worked each day; leave the rest to insulate the ground. TD-20H DRESSTA