REFERENCE ONLY 140497 PN=BO S11.0MLM.AG ·19·09AUG94 Service/As Required IMPORTANT: Never wash element in gasoline or any solvent. Never use compressed air on a wet element. Do not oil element. 4. Allow element to dry completely before using. This usually takes from one to three days. Do not oven dry or use drying agents. Protect element from freezing until dry. 72 Use extreme caution when washing filters as washing can damage filtering media which could result in failure. Although filter elements can be washed, replacement is highly recommended. Wash oily or sooty filter only if you have a second clean filter available since it may take up to 3 days to dry after washing. 1.
Blow dust from the filter with compressed air or flush with clean water. 2. Soak filter for at least 15 minutes in a solution of warm water and John Deere R36757 Filter Element Cleaner. Agitate the filter gently to flush out dirt after soaking. 3. Rinse element thoroughly from inside (B) with clean water. Keep water pressure under 280 kPa (2.8 bar) (40 psi) to avoid damaging filtering pleats. 5. Inspect element before installing. (See INSPECTING PRIMARY FILTER ELEMENT, later in this section.) WASHING PRIMARY FILTER ELEMENT