hitachi — MC Fault Code 11209

TROUBLESHOOTING / Troubleshooting A MC FAULT CODE 11209 Fault Code Influenced Control 11209-3 Pump Torque Decrease Control: Disabled 11209-4 Pump Torque Decrease Control: Disabled Disconnect connector MC-C in MC. Check for continuity between terminal #C12 of harness end of connector and terminal #2 of harness end of connector in implement pressure sensor. Open circuit in harnees between MC and implement pressure sensor. NO YES Disconnect connector of implement pressure sensor. Check if voltage between terminals #1 and #3 of harness end of connector is 5 ± 0.5 V. NO Open circuit in harness between MC and implement pressure sensor (terminal #3).

Check if voltage between terminal #1 of harness end of connector in implement pressure sensor and vehicle frame is specification. YES Switch implement pressure sensor with normal pressure sensor and retry. Check if fault code disappears. · Key switch: ON NO Open circuit in harness between MC and implement pressure sensor (terminal #1). · Key switch: ON · Specification: 5 ± 0.5 V NO YES Faulty implement pressure sensor. Connector (Harness end of connector viewed from the open end side) MC Connector MC-C Implement Pressure Sensor Connector C1 #C12 C10 1 2 3 C23 C31 T5-5-78 Trouble Cause Abnormal Implement Pressure Sensor High Voltage Output voltage:

4.75 V or higher Abnormal Implement Pressure Sensor Low Voltage Output voltage: Less than 0.25 V Faulty MC. YES