TROUBLESHOOTING / Troubleshooting A PILOT FAILURE MC FAULT CODE 11312 Disconnect connector MC-C in MC. Check for continuity between terminal #C1 of harness end of connector and terminal #2 of harness end of connector in pressure sensor. NO Open circuit in harness between MC and pressure sensor. YES Disconnect connector of pressure sensor. Check if voltage between terminals #1 and #3 of harness end of connector is 5 ± 0.5 V. Open circuit in harness between MC and pressure sensor (terminal #3). Switch pressure sensor with normal pressure sensor and retry. Check if fault code disappears. NO · Key switch:
ON YES Check if voltage between terminal #1 of harness end of connector in pressure sensor and vehicle frame is specification. · Key switch: ON · Specification: 5 ± 0.5 V NO NO Open circuit in harness between MC and pressure sensor (terminal #1). Faulty pressure sensor. YES Connector (Harness end of connector viewed from the open end side) MC Connector MC-C Service Brake Pressure Sensor Connector C10 C1 #C1 C31 C23 T5-5-79 Fault Code Trouble Cause Influenced Control 11312-3 Abnormal Brake Pedal Pressure Sensor (Service Brake Pressure Sensor) High Voltage Voltage:
4.75 V or higher • Clutch Cut-Off Control 11312-4 Abnormal Brake Pedal Pressure Sensor (Service Brake Pressure Sensor) Low Voltage Voltage: Less than 0.25 V • Clutch Cut-Off Control Faulty MC. YES 1 2 3