TROUBLESHOOTING / Troubleshooting B T5-6-7 Evaluation by Fault Code Evaluation by Monitor Function NOTE Descriptions of Control (Operational Principle Section in T/M) MC: 11103 MC Monitor Item: Required engine speed deviation, En- gine speed deviation, Accel- erator pedal, ECM Monitor Item: Actual engine speed, Target engine speed • If MC malfunctions, ECM set engine speed to 1000min-1. In this case, if the accelerator dedal wiring is connected to ECM directly, engine speed control becomes possible. T2-1 ECM: 110 ECM Monitor Item: Coolant temperature Monitor Unit Monitor Item:
Radiator coolant temperature (possible to be displayed by using the service mode on monitor) • The harnesses from same sensors are connected to ECM and the monitor unit respectively. If both temperature displays are abnormal, the sensor may be faulty. If one temperature display is abnormal, the controller including the abnormal harness may be faulty. T2-1 - MC Monitor Item: Service brake oil level switch - - - Monitor Unit Monitor Item: Air filter restriction - - - Monitor Unit Monitor Item: Fuel level • If the circuit is opened or shorted, the fuel gauge pointes to ”E”. - MC: 11901 MC Monitor Item:
Hydraulic oil temperature (possible to be displayed by using the service mode on monitor) - T2-1, T2-3 - - - T2-1 - - - T2-1 - MC Monitor Item: Boom angle, Angle sensor learning status • If the angle sensor learning is not completed, the lift arm stop position cannot be set. (Refer to T4-6.) T2-1 - - - T2-1, T2-3, T3-12 - - - -