TROUBLESHOOTING / Troubleshooting B T-9 Clutch cut-off is not operated. Check the wiring connections first. Refer to T2-1-36 to 37 in the Control System group/ SYSTEM section. Monitor clutch cut-off mode of MC monitor item on Dr. ZX. Shift clutch cut-off posi- tion switch to S, N and D in this order. Check if Low, Medium and High are displayed on screen in this order. Refer to Troubleshooting A. YES NO Disconnect connector in clutch cut-off position switch. Check if voltages at terminals #2, #3, #4 and #5 of harness end of connector are 1V, 2V, 3V and 4V respec- tively. NO YES Normal. · Key switch: ON NO Execute troubleshooting of each controller by using Dr. ZX.
Check if any fault codes are dis- · Engine: Running · Key switch: ON YES Refer to Troubleshooting A. Connector (Harness end of connector viewed from the open end side) Clutch Cut-Off Position Switch Connector Monitor Unit Connector 1-B #2 #3 #B28 #4 #5 #B31 #B30 #B29 T4GB-05-05-002 T5-6-74 1 2 3 4 5 6