hitachi — Malfunction of High Beam Indicator

TROUBLESHOOTING / Troubleshooting C YES Open circuit in harness be- tween high beam relay (AR3) and head light switch. YES Open circuit in harness be- tween high beam relay (AR3) and monitor unit. Connect the discon- nected connector. Disconnect connector 2-B in monitor unit. Check if voltage at ter- minal #22 of harness end connector is 0 V. NO YES Check for continuity be- tween terminals #2 and #4 of head light switch end connector. Faulty logic circuit in monitor unit or burnt indicator light. NO Faulty head light switch. NO YES Faulty head light switch. Shorted circuit in harness be- tween high beam relay (AR3) and head light switch.

NO Connector (Harness end of connector viewed from the open end side) Monitor Unit Connector 2-B Head Light Switch Connector High Beam Relay Connector 22 2 1 3 T4GB-05-05-002 T183-05-04-003 4 T5-7-15