Page 5 - 6 Section 5 – Maintenance Procedures CFP83 Series Procedure 4 Check Lubricating Oil Level CAUTION Never operate the engine with oil level below the L (low) mark or above the H (high) mark. Poor engine performance or engine damage can occur. NOTE : Wait at least 15 minutes after shutting off the engine to check the oil level. This allows time for the oil to drain into the oil pan. The engine must be level when checking the oil level to make sure the measurement is correct. Check the oil level on the dipstick. NOTE : If the lube oil is excessively high, troubleshoot as per Oil Level Rises in Section 7. If the lube oil level is greater than the high mark, drain the excessive oil.
Refer to Drain Oil in Change Lubricating Oil and Filters in Section 7. If the lube oil level is below the low mark, add oil. Refer to Fill Oil in Change Lubricating Oil and Filters later in this Section. NOTE: If the lube oil is excessively low, troubleshoot as per Lubricating Oil Consumption Excessive in Section 12. Oil Capacity (Low to High Mark Oil): 3.8 liters [4 U.S. qt] For additional lubricating oil recommendations and oil pan capacity information, refer to Lubricating Oil Recommendations and Specifications and Lubricating Oil System Specifications in Section 7. Procedure 5 Drain Fuel-Water Separator Cummins Inc.
requires a fuel-water separator or fuel filter be installed in the fuel supply system. Drain the water and sediment from the separator daily. WARNING Drain the water-fuel separator into a container and dispose of in accordance with local environmental regulations. Drawing No. 9777, Section 5, Rev. 02-07