Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 5 – Maintenance Procedures Page 5 - 7 CFP83 Series Spin-on Type Procedure 6a Inspect Aftercooler Piping (CFP83-F10, F20, F30) Inspect the charge air piping and hoses daily for holes, cracks, or loose connections. Tighten the hose clamps, if necessary. Refer to the manufacturer's specifications for the correct torque value. Inspect the charge air cooler for dirt and debris blocking the fins. Check for cracks, holes, or other damage. If damage is found, refer to the Charge Air Cooler Removal/Installation in Section 7. Inspect the intake piping daily for wear points and damage to piping, loose clamps, or punctures that can damage the engine.

Replace damaged pipes and tighten loose clamps as necessary to prevent the air system from leaking. Torque Value: 8 N•m [72 in-lb] Check for corrosion under the clamps and hoses of the intake system piping. Corrosion can allow corrosive products and dirt to enter the intake system. Disassemble and clean as required. Drawing No. 9777, Section 5, Rev. 02-07