Page 5 - 14 Section 5 – Maintenance Procedures CFP83 Series Every Three Months or 250 Hours General Information All checks or inspections listed under daily or previous maintenance intervals must also be performed at this time, in addition to those listed under this maintenance interval. Procedure 13 Check Hose Condition Inspect the lubricating, fuel, and cooling system hoses and hose connection for leaks or deterioration. Particles of deteriorated hose can be carried through the cooling system and slow or partially stop circulation. Procedure 14 Check Engine Coolant Heater NOTE : Do not perform this inspection procedure until 24 hours after shutting off the engine.
The engine coolant heater must maintain an engine coolant temperature of 49 °C (120 °F) or above. The engine block must be warm to the touch in the water jacket areas. If the heater does not appear to be working correctly, contact a Cummins Authorized Repair Location. Procedure 15 Inspect Heat Exchanger Zinc Plug Remove the zinc plug. Inspect the plug. If it has eroded over 50 percent, replace the plug (Cummins Fire Power Part No. 9750), and brass fitting (Cummins Fire Power Part No. 9751). Drawing No. 9777, Section 5, Rev. 02-07