Section 5 – Maintenance Procedures Page 5 - 15 CFP83 Series Procedure 16 Inspect Electrical Components Clean and tighten any loose electrical connections. Follow the manufacturer’s recommended procedures for servicing the electrical components and batteries. Procedure 17 Check Turbocharger Mounting Nuts Check the turbocharger mounting nuts. Tighten the mounting nuts. Torque Value: 65 N•m (50 ft-lb) Procedure 18 Check Engine Mounting Bolts CAUTION Damaged engine mounts and brackets can cause engine misalignment. Driveline component damage can result in vibration complaints. Inspect all rubber-cushioned mounts for cracks or damage.
Inspect all mounting brackets for cracks or damaged bolt holes. Check the torque on the engine mounting nuts and bolts. Tighten any that are loose. Procedure 19 Check Cooling System Condition WARNING Check the coolant level only when the engine is stopped. Wait until the coolant temperature is below 50 °C (120 °F) before removing the pressure cap, (Cummins Fire Power Part No. 11407). Failure to do so can cause personal injury from heated coolant spray. Drawing No. 9777, Section 5, Rev. 02-07