Section 5 – Maintenance Procedures Page 5 - 17 CFP83 Series NOTE : Follow the manufacturer's instructions when cleaning or replacing the air cleaner element. NOTE: Do not remove the felt washer from the indicator. The felt washer absorbs moisture. Check the air cleaner service indicator, if equipped. A mechanical restriction indicator is available to indicate excessive air restriction through a dry-type air cleaner. This instrument can be mounted in the air cleaner outlet or on the instrument panel. Change the filter element when the red indicator flag (2) is at the raised position in the window (1). After the air cleaner has been serviced, push the button (3) to reset the service indicator.
NOTE : Never operate the engine without an air cleaner. Intake air must be filtered to prevent dirt and debris from entering the engine and causing premature wear. Procedure 21 Inspect Air Intake System Piping Procedure 22 Check Fuel Pump Inspect the fuel injection pump mounting nuts, including the support bracket, for loose or damaged hardware. Drawing No. 9777, Section 5, Rev. 02-07 Inspect the intake piping for cracked hoses, loose clamps, or punctures that can allow dirt and debris to enter the engine. Tighten or replace parts as necessary to make sure the air intake system does not leak. Check for corrosion of the intake system piping under the clamps and hoses.
Corrosion can allow corrosive products and dirt to enter the intake system. Disassemble and clean as required.