Section 5 – Maintenance Procedures Page 5 - 41 CFP83 Series Check the belt for damage. Transverse (across the belt width) cracks are acceptable. Longitudinal (direction of the belt length) cracks that intersect with transverse cracks are not acceptable. If the belt is frayed or has any piece of material missing, the belt is unacceptable and needs to be replaced. With the belt removed, verify that the tensioner arm stop is in contact with the spring case stop. If these two are not touching, the tensioner must be replaced. With the belt removed, check to be sure that the tensioner pulley rotates freely.
Measure the clearance between the tensioner spring case and the tensioner arm to verify tensioner wear- out and uneven bearing wear. If the clearance exceeds 3 mm [0.12 in] at any point, the tensioner failed and must be replaced as a complete assembly. Experience has revealed that tensioners generally will show a larger clearance gap near the lower portion of the spring case, resulting in the upper portion rubbing against the tensioner arm. Always replace the belt when a tensioner is replaced. Drawing No. 9777, Section 5, Rev. 02-07