Section 5 – Maintenance Procedures Page 5 - 43 CFP83 Series Remove valve cover. Locate top dead center for cylinder No. 1 by rotating the crankshaft slowly while pressing on the engine timing pin. The barring gear inserts into the flywheel housing and engages the flywheel ring gear. The engine can then be rotated by hand using a 1/2-inch ratchet or breaker bar. When the engine timing pin engages the hole in the camshaft gear, cylinder No. 1 is at top dead center on the compression stroke. CAUTION Be sure to disengage the engine timing pin after locating top dead center to prevent damage to the engine timing pin. Drawing No. 9777, Section 5, Rev. 02-07