Page 7-10 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Belt Guard Removal/Installation (Cont) CFP83-F10, F20, F30 Only Close the aftercooler coolant vent. All Close the coolant drain valve. Refill engine coolant as required Refer to Drain and Flush Coolant System in Section 5. Install the coolant system pressure cap (Cummins Fire Power Part No.11407). Reconnect the coolant heater power supply. For safety reasons, both batteries must be re- connected before putting the engine and fire protection system controller back in service. Wear safety glasses when reconnecting batteries! Reconnect the batteries at their terminals after all service work has been completed. Drawing No.
9777, Section 7, Rev. 02-07