Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 7 – Adjustment, Repair, and Replacement Page 7-45 CFP83 Series Water Temperature Gauge Removal/Installation Prepare Place the AUTO/MANUAL Switch at the local panel in the MANUAL position. WARNING Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. Disconnect the positive battery cables from both batteries. Disconnect any customer supplied battery chargers. Remove Use a nut driver or equivalent to remove the control panel’s mounting bolt.

Pull the control panel out from the enclosure so that it is supported by the piano hinge on the bottom. NOTE : Check and tag all wires with location tags prior to removal. Remove the two dark blue [METER +] wires from the [I] terminal on the gauge. Remove the single black ground wire from the [G] terminal on the gauge. Remove the single [WTG] wire from the [S] terminal on the gauge. NOTE : Catch the gauge as the meter bracket is removed. Remove the two nuts and the meter bracket from the back of the panel. Remove the gauge from the panel. Drawing No. 9777, Section 7, Rev. 02-07