Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 7 – Adjustment, Repair, and Replacement Page 7-55 CFP83 Series Coolant Thermostat Removal/Installation (Cont) Drawing No. 9777, Section 7, Rev. 02-07 Install the Thermostats Use the appropriate section as follows: If installing a new thermostat, use the Install New Thermostat and Shims subsection. If reusing existing thermostat and shims, use the Reinstall Thermostat and Shims subsection. Install New Thermostat and Shims CAUTION Do not shim the thermostats beyond the top of the block. Temporarily position the thermostats in the bore. Measure the distance from the thermostat flange to the top of the block surface of each thermostat to determine the proper shim(s) to use. NOTE:

The service shims included are 0.25 mm [0.010 in], 0.50 mm [0.020 in], 0.75 mm [0.030 in], and 1 mm [0.040 in]. NOTE: Any combination of shims can be used, but stacking is limited to a maximum of two shims per bore. Select the appropriate combination of shims that will bring each thermostat’s height as close to the top of the block as possible. Remove each thermostat. Insert the selected shims into each bore, making sure each shim is seated properly in the bore. Install the thermostats on top of the service shim(s) in the thermostat flanges. NOTE: They can be within 0.23 mm [0.009 in] of flush with the top of the block, without being above the top of the block.

Check that the thermostats are correctly installed. Continue to Install the Thermostat Housing.