Section 7 – Adjustment, Repair, and Replacement Page 7-61 CFP83 Series Coolant Water Pump Removal/Installation (Cont) Clean Clean the sealing surface on the cylinder block. If reusing the water pump, clean the sealing surface on the water pump. Inspect for Reuse NOTE : A minor streak or chemical buildup at the weep hole is not justification for water pump replacement. The water pump seal design requires a coolant film for lubrication and cooling. Therefore, it is normal to observe a minor chemical buildup or streaking at the weep hole. Inspect the water pump body for indications of water leakage at the weep hole.
If a repeating drip of coolant is observed, replace the water pump with a new unit. NOTE : A plugged weep hole can cause the water pump to fail. A small screwdriver or a small tool can be used to remove any debris. Inspect the weep hole to make sure it is open. NOTE : Replace the water pump if it is damaged. Inspect the water pump housing and impeller for any physical damage. Drawing No. 9777, Section 7, Rev. 02-07