Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 7-62 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Coolant Water Pump Removal/Installation (Cont) Install If reusing the original water pump, install a new water pump seal (Cummins Part No 3902089) onto the water pump housing. Otherwise, install a new water pump kit (Cummins Part No 3800974). Position the water pump and start the upper capscrew. Position the alternator link and start the two lower capscrew. Tighten the three capscrews at the water pump. Torque Value: 24 N•m [18 ft-lb] Follow-Up Install the alternator link at the alternator. Refer to Alternator Removal/Installation in this section. Install the upper engine coolant hose.

Refer to Coolant Hose Removal/Installation in this section. Install the drive belt. Refer to Belt Removal/Installation in this section. Install the belt guard. Refer to Belt Guard Removal/Installation in this section. Reconnect the lower engine coolant hose. Refer to Coolant Hose Removal/Installation in this section. Refill the coolant. Refer to Drain and Flush Cooling System in Section 5. Drawing No. 9777, Section 7, Rev. 02-07