Section 7 – Adjustment, Repair, and Replacement Page 7-63 CFP83 Series Coolant Water Pump Removal/Installation (Cont) For safety reasons, both batteries must be re- connected before putting the engine and fire protection system controller back in service. Wear safety glasses when reconnecting batteries! Reconnect the batteries at their terminals after all service work has been completed. Start the engine. Refer to Local Starting Procedure for Testing in Section 3. Observe that raw water is flowing through the coolant heat exchanger. NOTE : A leak at the water pump weep hole is not justification for water pump replacement.
The water pump seal design requires a coolant film for lubrication and cooling. Therefore, it is normal to observe an occasional drip. Check for leaks. Repair any leaks. Check that the drive belt makes no unusual noises. Check that the alternator is charging. NOTE : If temperature does not stabilize, stop the engine and refer to Coolant Temperature Above Normal or Coolant Temperature Below Normal (Engine Running) in Troubleshooting Section 12. Check that engine operating temperature stabilizes between about 82 and 93 o C [180 and 200 o F]. Check that no coolant hoses are collapsed. After the thermostat operation has been checked, stop the engine.
Refer to Local Starting Procedure for Testing in Section 3. Recheck the coolant level. Refer to Check Coolant Level in Section 5. Place the AUTO/MANUAL rocker switch in the AUTO position. Return the fire protection system to operating status. Drawing No. 9777, Section 7, Rev. 02-07