Page 7-64 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Coolant Filter Assembly Removal/Installation Prepare WARNING Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap (Cummins Fire Power Part No. 11407). Heated coolant spray or steam can cause personal injury. WARNING Coolant is toxic. Keep away from children and pets. If not reused, dispose of in accordance with local environmental regulations. Place the fire protection system in a safe mode for engine service. Place the AUTO/MANUAL rocker switch in the MANUAL position.
For safety reasons, both batteries must be disconnected before performing service on the Firepump Engine or on any of its controls. Before disconnecting the batteries, place the Firepump Controller in its appropriate service position in order to avoid a “Battery Failure” alarm. Wear safety glasses when disconnecting batteries! Next, disconnect both batteries at their terminals. Remove the coolant system pressure cap (Cummins Fire Power Part No. 11407). Turn the shutoff valve to the OFF position by rotating the knob from vertical to horizontal in the direction shown. Drawing No. 9777, Section 7, Rev. 02-07