Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 7 – Adjustment, Repair, and Replacement Page 7-65 CFP83 Series Coolant Filter Assembly Removal/Installation (Cont) Remove WARNING A small amount of coolant can leak when servicing the coolant filter with the shutoff valve in the OFF position. To reduce the possibility of personal injury, avoid contact with hot coolant. Remove and discard the coolant filter. Clean the filter housing with a dry clean rag. Install CAUTION Do not allow oil to get into the filter. Apply a thin film of lubricating oil to the gasket sealing surface before installing the new coolant filter. CAUTION Mechanical over-tightening can distort the threads or damage the filter head.

Install the coolant filter on the filter head. Tighten the filter until the gasket contacts the filter head surface. Tighten the coolant filter an additional 1/2 to 3/4 of a turn, or as specified by the filter manufacturer. CAUTION The valve must be in the ON position to prevent engine damage. Turn the shutoff to the ON position by rotating the knob from horizontal to vertical in the direction shown. Drawing No. 9777, Section 7, Rev. 02-07