Section 7– Adjustment, Repair, and Replacement Page 7-67 CFP83 Series Alternator Checks and Testing Alternator Wiring Integrity Check NOTE : Refer to Drawing 10423 Sheet 1, Drawing 10423 Sheet 2, and Drawing 9767 in Section 13 for schematic details. WARNING Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the battery compartment before servicing the batteries. WARNING To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. Check the battery and all wiring connections for damage. Refer to Battery Cables and Connections in this section.
Check all connections for tightness and cleanliness. Include both the slip connectors at the alternator and connections at the battery. NOTE : Continuity should be in the single digit Ohms or less. Resistance to ground should be in the mega-Ohm range. Refer to any applicable customer criteria. Using a digital multimeter or other test equipment, check for continuity between terminals. Check also the insulation resistance to ground. Correct any electrical faults. Alternator Mechanical Check Start the engine. Refer to Normal Local Starting Procedure in Section 3. Visually check the drive belt and alternator pulley to be sure the alternator is rotating.
Note any unusual noises such as from belt whine or alternator mechanical fault. Stop the engine. Correct any mechanical failures. Drawing No. 9777, Section 7, 02-07