Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 7– Adjustment, Repair, and Replacement Page 7-75 CFP83 Series Engine Harness Removal/Installation Drawing No. 9777, Section 7, 02-07 Prepare Place the fire protection system in a safe mode for engine service. Place the AUTO/MANUAL rocker switch in the MANUAL position. NOTE: Refer to Battery Removal/Installation in this section for detailed instructions for disconnecting the battery cable clamps. Disconnect the negative battery cable from Battery A. Disconnect the negative battery cable from Battery B. Remove NOTE: Refer to Drawing 8513 Sheet 1 in Section 13 for a depiction of the engine wiring harness. NOTE: Ensure that each terminal is properly labeled for ease of reconnection.

Disconnect the harness connection at each terminal. Install NOTE: Refer to Drawing 8513 Sheet 1 in Section 13 for a depiction of the engine wiring harness. Connect the harness connection at each terminal.