Page 7-78 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Voltmeter Removal/Installation (Cont) Drawing No. 9777, Section 7, Rev. 02-07 Install Orient the voltmeter in the cutout in the 12 14 10 16 electrical panel. 8 18 Position the mounting bracket on the gauge. Install the mounting nuts. VOLTS Reconnect the electrical wires on the studs in the same positions as they were originally installed. Tighten the nuts on the studs. For safety reasons, both batteries must be re- connected before putting the engine and fire protection system controller back in service. Wear safety glasses when reconnecting batteries!
Reconnect the batteries at their terminals after all service work has been completed. Place the AUTO/MANUAL rocker switch in the AUTO position. Return the fire protection system to operating status.